HP StorageWorks 2.12 Edge Switch - Manual (Page 225)

Information and Error Messages
225 Edge Switch Element Manager User Guide
Error transferring files
< message >.
An error occurred
while transferring files
from the PC hard drive
to the Element
Manager. The
message varies,
depending on the
problem.
Try the file transfer operation
again. If the problem persists,
contact the next level of support.
Feature not supported.
The ‘product name’
must be running
version 05.00.00 or
higher.
The firmware version
on the hardware
product (switch or
director) is lower than
05.00.00. This
message only displays
if the optional Open
Trunking feature is
installed.
Install firmware version 5.00.00
or higher on the hardware
product.
Field cannot be blank. The data field requires
an entry and cannot
be left blank.
Enter appropriate information
in the Data field.
Field has exceeded
maximum number of
characters.
The maximum number
of data entry
characters allowed in
the field was exceeded.
Enter the information using the
prescribed number of
characters.
File transfer aborted. You aborted the file
transfer process.
Information message only.
File transfer is in
progress.
A firmware file is being
transferred from the
HAFM appliance hard
drive, or a data
collection file is being
transferred to a CD.
Informational message
only—no action is required.
Firmware download
timed out.
The director or switch
did not respond in the
time allowed. The
status of the firmware
install operation is
unknown.
Retry the operation. If the
problem persists, contact the
next level of support.
Firmware file I/O
error.
A firmware download
operation aborted
because a file I/O
error occurred.
Retry the operation. If the
problem persists, contact the
next level of support.
Table 8: Element Manager Messages (Continued)
Message Description Action