HP StorageWorks 2.12 Edge Switch - Manual (Page 215)

Information and Error Messages
215 Edge Switch Element Manager User Guide
Cannot disable
Insistent Domain ID
while Fabric Binding is
active.
You attempted to
disable the Insistent
Domain ID parameter
through the Configure
Switch Parameters
dialog box, but Fabric
Binding is enabled.
Disable Fabric Binding through
the Fabric Binding dialog box
before disabling these
parameters.
Cannot enable
beaconing on a failed
FRU.
Occurs when selecting
Enable Beaconing
option for a failed
FRU.
Replace FRU and enable
beaconing again or enable
beaconing on operating FRU.
Cannot enable
beaconing while the
system light is on.
Occurs when choosing
Enable Beaconing
option for a failed
FRU.
Replace FRU and enable
beaconing again or enable
beaconing on an operating
FRU.
Cannot enable
beaconing while the
system error light is on.
Beaconing cannot be
enabled while the
system error light is on.
Select Clear System Error Light
from Product menu to clear
error light, then enable
beaconing.
Cannot enable Open
Trunking while
Enterprise Fabric Mode
is active and the switch
is offline.
Enterprise Fabric mode
is active and the switch
or director is online
and you attempted to
enable Open Trunking.
This message only
displays if the optional
Open Trunking feature
is installed.
Perform either of the following
steps:
■
Disable Enterprise Fabric
Mode option by selecting the
appropriate fabric in the
Fabric Tree portion of the
HAFM Manager window
(Fabrics tab) and then
selecting Enterprise Fabric
Mode from the Fabrics menu.
When the Enterprise Fabric
Mode dialog box displays,
click Start and follow
prompts to disable the
feature.
■
Set the switch or director
offline through the Set Online
State dialog box. Display this
dialog box by selecting Set
Online State from the
Element Manager
Maintenance menu.
Table 8: Element Manager Messages (Continued)
Message Description Action