HP StorageWorks 2.12 Edge Switch - Manual (Page 213)

Information and Error Messages
213 Edge Switch Element Manager User Guide
Element Manager Messages
This section lists Element Manager information and error messages in
alphabetical order.
Table 8: Element Manager Messages
Message Description Action
A Preferred Path
already exists between
this Source Port and
this Destination
Domain ID. Please
re-configure the
desired path.
For any source port,
only one path may be
defined to each
destination domain ID.
On the Add/Change Preferred
Path dialog box, change the
preferred path.
Activating this
configuration will
overwrite the current
configuration.
Confirmation to
activate a new address
configuration.
Click Yes to confirm activating
the new address configuration
or No to cancel the operation.
All configuration
names must be unique.
All address
configurations must be
saved with unique
names.
Save the configuration with a
different name that is unique to
all saved configurations.
All FPM ports will be
held inactive while the
director is configured
to 2 Gb/sec speed. Do
you want to continue?
Occurs when FPM
cards are installed in
the director and
director speed is being
set to 2 Gb/sec in the
Configure Switch
Parameters dialog box.
Replace FPM cards with UPM
cards (UPM cards operate at 1
and 2 Gb/sec) or set the
director speed to 1 Gb/sec.
All port names must be
unique.
A duplicate Fibre
Channel port name
was configured. All
port names must be
unique.
Reconfigure the Fibre Channel
port with a unique name.
All port names must be
unique.
A duplicate port name
was entered. Every
configured port name
must be unique.
Reconfigure the port with a
unique name.
An Element Manager
instance is already
open.
Only one instance of
the Element Manager
can be open at one
time.
Close the open Element
Manager so the desired
instance of the Element
Manager can be opened.