Figure 39: enable feature key dialog box, No feature key dialog box, Figure 40: no feature key dialog box – HP StorageWorks 2.12 Edge Switch User Manual
Page 133: Y dialog box, Figure 39, Displays with a
Configuring the Switch
133
Edge Switch Element Manager User Guide
Figure 39: Enable Feature Key dialog box
5. Click Activate to activate the new feature key.
An IPL will occur, during which the Ethernet connection between the HAFM
appliance and switch is momentarily interrupted. This will not disrupt Fibre
Channel traffic.
Note:
If you click Activate, all current features will be replaced with new features. That
is, if there are features shown in the current list that are not shown in the new list, then
those features will be removed from the switch.
6. When you are finished configuring the switch, you can back up the
configuration data. For more information, see “
No Feature Key Dialog Box
If you attempt to access a feature for which a feature key was not enabled, a No
Feature Key dialog box displays.
Figure 40: No Feature Key dialog box
At this point, you must enter the Element Manager feature key. After you enter a
valid feature key, the Enable Feature Key dialog box displays.