Reset configuration – HP StorageWorks 2.12 Edge Switch User Manual
Page 170
Using Maintenance Features
170
Edge Switch Element Manager User Guide
Reset Configuration
Note:
You must have maintenance authorization feature permissions to access this
feature.
This option resets all configuration data input through options in the
Configuration menu, zoning configurations, and switch addressing to
factory-default values. Since the current IP address for the switch may not match
the factory default address, the Ethernet link between the switch and the HAFM
appliance may drop and not reset.
Before using this option, record the switch’s current IP address, which displays
below the switch’s icon in the HAFM Physical/Topology Map view (Display
Options set to Network Address). You can also find the current IP address
through the EWS interface.
After resetting the configuration, you must reset the original address on the switch
through the maintenance port or the EWS interface to maintain LAN connections
and communication with the HAFM appliance.
Use the following procedure to reset your product configuration:
1. Set the switch offline. For instructions, see “
2. Click Maintenance > Reset Configuration. The following warning displays:
Caution:
This operation will reset all switch configuration data and
non-volatile settings to factory default values. All optional features will also be
disabled. The switch must be offline to continue.
Note:
If you have enabled features that add additional port function since the switch
was shipped from the factory, these features will be disabled (factory default) when the
configuration is reset. Only those ports that were enabled at the factory will function.
You will have to enable the additional port function features again through the
Configure Feature Key dialog box. See “
more information.