Rainbow Electronics W90N740 - Manual (Page 88)

W90N740
- 84 -
Set this bit to enable the interrupt, which is generated to indicate 16 collisions occur while transmitting the
same packet.
EnNCS [20]: Enable No Carrier Sense interrupt
Default value: 0
Set this bit to enable the interrupt, which is generated to indicate no carrier sense is presented during
transmission.
EnEXDEF [19]: Enable Defer interrupt
Default value: 0
Set this bit to enable the interrupt, which is generated to indicate that the defer time exceeding
0.32768ms operated at 100Mbs/s or 3.2768ms operated at 10Mbs/s.
EnTXCP [18]: Enable Transmit Completion interrupt
Default value: 0
Set this bit to enable the interrupt, which is generated when the MAC transmits, or discards one packet.
EnTXEMP [17]: Enable Transmit FIFO Empty interrupt
Default value: 0
Set this bit to enable the interrupt, which is generated when MAC transmit FIFO becomes empty
(underflow) during a packet transmission.
EnTXINTR [16]: Enable Interrupt on Transmit interrupt
Default value: 0
Set this bit to enable the interrupt, which is generated if a transmission of a packet causes an interrupt
condition.
EnCFR [13]: Enable Control Frame Receive Interrupt
Default value: 0
Set this bit to enable the interrupt, which is generated if the incoming frame is a MAC control frame.
EnNATErr [13]: Enable NAT Processing Error Interrupt
Default value: 0
Set this bit to enable the interrupt, which is generated if there is any error during NATA do the NAT
processing.
EnNATOK [12]: Enable NAT Processing OK Interrupt
Default value: 0