Rainbow Electronics W90N740 - Manual (Page 106)

W90N740
- 102 -
TXABT [21]: Transmit Abort
Default value: 0
The bit is set to indicate 16 collisions occur while transmitting the same packet.
NCS [20]: No Carrier Sense
Default value: 0
Set to indicate no carrier sense is presented during transmission.
EXDEF [19]: Defer
Default value: 0
This bit is set to indicate that defer time exceeding 0.32768ms operated at 100Mbs/s and 3.2768ms
operated at 10Mbs/s. When the EnEXDEF in MIEN is set, the internal 15-bit counter will automatically
count the deferred bit time and generate interrupt when the counter overflows.
TXCP [18]: Transmit Completion
Default value: 0
This bit is set when the MAC transmits, or discards one packet.
TXEMP [17]: Transmit FIFO Empty
Default value: 0
Set when MAC transmitting FIFO becomes empty (underflow) during a packet transmission.
TXINTR [16]: Interrupt on Transmit
Default value: 0
This bit is set if transmission of a packet caused an interrupt condition.
CFR [14]: Control Frame Receive
Default value: 0
This field will be set if the incoming frame is a MAC control frame (type==8808h).
NATErr [13]: NAT Processing Error
Default value: 0
This field will be set if there is any error during NATA do the NAT processing. If the status and EnNATErr
in MIEN are both set, the EMC_RxINT will be triggered.
NATOK [12]: NAT Processing OK
Default value: 0