Grass Valley Turbo iDDR v.2.3 - Manual (Page 81)

Turbo iDDR User Guide 81
Creating Subclips
The Subclip display appears with a new subclip loaded and the front panel Mark-In
and Mark-Out buttons are flashing indicating that no mark-in or mark-out point are
defined. The default subclip name follows the form name>-, for example, if the source clip name is PlayoffGame, the
subclip name is PlayoffGame-1.
3. To rename the subclip, press MENU , then choose Rename . Use the onscreen
keyboard or and external keyboard to rename the subclip.
Renaming the subclip creates a new seed name. For example, if you rename the
subclip PlayoffGame-1 to Highlight, subsequent subclips created are named
Highlight-1, Highlight-2, and so on.
4. Use the front panel transport controls to locate the desired frame, then press the
MARK-IN button.
5. Use the front panel transport controls to locate the desired frame, then press the
MARK-OUT button.
6. Press Accept . The subclip is saved and ejected, then a new subclip name is
created.
NOTE: If the Accept button does not flash, but instead the clip is saved and a new
subclip is loaded, the iDDR is in Auto-subclip mode. See “About Auto Subclip mode”
on page 82 .
NOTE: Clicking the Eject button prior to pressing the Accept button closes Subclip
mode without creating a new clip. Both of these buttons are used to exit Subclip mode.
Mark Labels
(Flash until set)
Subclip Name
Subclip Location
Flashes when both
mark-in and mark-out
have been set. Press
to accept marks and
create a new subclip. Clears any subclip
marks that have
been set.