Grass Valley Turbo iDDR v.2.3 - Manual (Page 124)

124 Turbo iDDR User Guide
Chapter 4 Operation: AppCenter Workstation
Selecting the channel mode
When the Turbo iDDR is started, each channel comes up in its last used mode. From
the factory, Recorder mode starts on the record channel, and Player mode starts on
both play channels.
To change channel modes, in the monitor pane, select the channel mode drop-down
list
for the channel, then choose a mode.
The selected mode replaces the current mode and appears in the channel’s space in
the channel pane. The channel becomes the selected channel.
Using on-screen transport controls
All channel modes have on-screen transport controls.
Recording clips
The recorder display is used to record clips on the iDDR. You can play the clip while
it is still recording, or you can finish the recording, and then play the clip or add it to
a playlist.
This section includes the following topics:
• “About recording clips” on page 125
• “About loop record mode” on page 125
• “Guide to using Recorder mode” on page 128
• “Before you record: Recorder settings checklist” on page 130
• “To record a clip” on page 131
• “Using IEEE 1394 Record mode” on page 135
• “Previewing a clip that is recording” on page 137
• “Changing the timecode source” on page 138
• “Selecting widescreen mode” on page 139
• “Changing the current bin” on page 139
• “Renaming a clip” on page 140
• “Viewing clip properties” on page 140
Cue to mark-out
Field Advance
(Single click to
advance one field.)
Cue to mark-in
Field Reverse
(Single click to
reverse one field.)
Record Forward Stop Rewind Play Progress Bar