Using front panel transport controls, Monitoring remote control communications, See “monitoring remote control communications – Grass Valley Turbo iDDR v.2.3 User Manual

Page 268

268

Turbo iDDR User Guide

Chapter 5 Remote Control

Using front panel transport controls

The following describes how to control playout using the transport controls on the
optional front panel. The control application must be configured to allow local
control. (

See “Select the control port and control mode” on page 255

Monitoring remote control communications

The Protocol Monitor button

is displayed in the AppCenter StatusBar when a

protocol application is running on an iDDR channel. The button flashes when any
channel is receiving remote control messages. Clicking the button opens the Protocol
Monitor dialog box which you can use to determine which channels are receiving
messages.

NOTE: The Protocol Monitor dialog will not open until a controller is connected and
at least one command set is sent.

To open the Protocol Monitor dialog box:

• Click the Protocol Monitor button

in the AppCenter StatusBar.

The dialog box displays the channel number and protocol being used, along with
the port number and control mode (Local or Protocol only). The green status LED
indicates the port is receiving protocol commands.

Front Panel Buttons

Action

Play

Stop

Rew

Previous Frame

Next Frame

Rew(hold)

Rewind until released

FF(hold)

Fast forward until released.

Stop + Rew

Cue previous clip (in a list) or cue to start. This stops playout.

Stop + FF

Cue next clip (in a list) or cue end. This stops playout.

Stop + Rew(hold)

Cue previous clip (in a list) or cue to start. This stops playout.

Stop + FF(hold)

Skip to the start of the preview clip. This stops playout.

Stop +

Play the selected clip

This manual is related to the following products:

Turbo iDDR v.2.1 Turbo iDDR v.2.2