Grass Valley Turbo iDDR v.2.3 - Manual (Page 179)

Turbo iDDR User Guide 179
Editing and rearranging events in a playlist
Editing event marks
Every event has a event-in point and an event-out point which refer to the first and last
frames displayed when the event plays. When first created, event marks are set to the
mark-in and mark-out of the source clip. You can edit the event marks in order to
reference only the desired media. Event marks can be cleared to reset them to the
marks specified in the source clip. (
See “Clearing event marks” on page 181 .)
The following restrictions apply when editing event marks:
• Event-in must precede the Event-out
• Event marks cannot be set outside the recorded media of the source clip.
NOTE: If more media exists outside the current mark, a <<< or >>> symbol is
displayed beneath the current event mark timecode.
To move event marks, view the event in Event view, then use one of the following
methods to move clip marks.
• “Using the Event In/Out buttons” on page 180
• “Using the timecode entry controls” on page 180
• “Using the event length control” on page 180