Grass Valley Turbo iDDR v.2.3 - Manual (Page 256)

256 Turbo iDDR User Guide
Chapter 5 Remote Control
3. Select the remote control port as follows:
a. Temporarily set the Remote/Local option to Local and Protocol control .
b. Use the Protocol Controller Port drop-down list to choose a remote control port.
You can select one of the RS422 ports (P1-P4), or the Ethernet port (AMP only).
4. If choosing AMP protocol, select the Remote/Local control option as required by
your control system:
• Protocol control only — Disables local control. The iDDR is controlled only
from the remote device. The iDDR display is used to monitor the channel status
and control operations as they take place remotely.
• Local and Protocol control — Local control is enabled. You can use the
AppCenter Workstation interface and front panel transport controls to control
the channel even though remote control is enabled. With this setting, you must
take care to avoid conflicts between local and remote control.
5. If you using AMP protocol to perform video network transfers, you must setup the
video network and the Controller Id as described in the Installation chapter. Refer
to
“Using an Ethernet connection” on page 271 .
6. Test the system and recheck settings, if required.