Grass Valley Turbo iDDR v.2.3 - Manual (Page 159)

Turbo iDDR User Guide 159
Creating Subclips
The Subclip display appears with a new subclip loaded. The In and Out buttons are
flashing indicating no mark-in or mark-out points are defined. The default subclip
name follows the form -, for example, if the source
clip name is PlayoffGame, the subclip name is PlayoffGame-1.
3. To rename the subclip, click the subclip name control , and
enter the new name in the Clip Name dialog, then click OK , or press Enter .
Renaming the subclip creates a new seed name. For example, if you rename the
subclip PlayoffGame-1 to Highlight, subsequent subclips created are named
Highlight-1, Highlight-2, and so on.
4. Enter the subclip marks as follows:
a. Using the transport controls, position the clip to the desired frame for mark-in,
then click the In button.
b. Using the transport controls, position the clip to the desired frame for mark-out,
then click the Out button.
Alternatively: Select the mark-in or mark-out timecode entry controls and enter
a specific timecode value.
Alternatively: Select the Length timecode entry control and enter a clip length,
then create either a mark-in or a mark-out point.
5. In Subclip view, click Accept .
The subclip is saved and ejected, then Player returns to Subclip view with a new
subclip name loaded.
NOTE: If the Accept button does not flash, but instead the clip is saved and a new
subclip is loaded, the iDDR is in Auto-subclip mode. See “About Auto Subclip mode”
on page 160 .
NOTE: Clicking the Source Clip button or the Eject button prior to pressing the
Accept button closes Subclip mode without creating a new clip. Both of these buttons
are used to exit Subclip mode.