Grass Valley Turbo iDDR v.2.3 - Manual (Page 150)

150 Turbo iDDR User Guide
Chapter 4 Operation: AppCenter Workstation
Playing a clip
Once a clip is loaded in Player mode, you can play the clip or search for a specific
frame of video using the transport controls. Use the links in the following table to find
information on playing clips.
Selecting loop play
Loop play allows the clip to play in a continuous loop until Stop is pressed. The Time
Dome is used to enable/disable loop play.
• Click the Time Dome , then choose Loop Mode in the pop-up menu.
Selecting E-to-E mode
In E-to-E mode, the record channel inputs are switched to the play channel audio and
video outputs (standard definition) when the play channel is in stop mode or when no
clip is loaded. This allows you to monitor the record channel inputs while recording.
To enable E-to-E mode:
• In the AppCenter Workstation main menu, select Player then E-to-E .
The following table describes play channel operation depending on the E-to-E
selection.
If you are using… Refer to…
Front Panel controls “Using the front panel controls” on page 51
On-screen transport controls “Using on-screen transport controls” on page 124
Keyboard shortcuts Appendix A, Keyboard Shortcuts on page 281
GPI input triggers “Setting GPI input triggers” on page 43
E-to-E Setting Play channel mode Play channel output
E-to-E Disabled Play, FF, Rewind Show clip
Stop Show clip
Eject Show black
E-to-E Enabled Play, FF, Rewind Show clip
Stop Show input a.
a.
Output is black if no video input is connected to R1. DVI-I output
does not support E-to-E.
Eject Show input
a.