H3C Technologies H3C SR8800 - Manual (Page 73)

57
[RouterC] ip route-static 192.168.1.0 24 GigabitEthernet4/1/1 192.168.2.1
[RouterC] ip route-static 100.1.1.1 24 null 0
CAUTION:
If you specify null 0 interface as the output interface for a static route, do not specify the IP address of a
directly connected network as the destination IP address.
4. Verify the configuration:
# Display the BFD session information of Router A.
display bfd session
Total Session Num: 1 Init Mode: Active
Session Working Under Ctrl Mode:
LD/RD SourceAddr DestAddr State Holdtime Interface
6/1 192.168.1.1 192.168.2.2 Up 1700ms GE4/1/2
# Display the RIP route 100.1.1.0/24 learned on Router A.
display ip routing-table 100.1.1.0 verbose
Routing Table : Public
Summary Count : 2
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 1
Preference: 100 Cost: 1
NextHop: 192.168.2.2 Interface: GigabitEthernet4/1/2
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 192.168.1.2 Neighbor : 192.168.2.2
Tunnel ID: 0x0 Label: NULL
State: Active Adv GotQ Age: 00h04m02s
Tag: 0
Destination: 100.1.1.0/24
Protocol: RIP Process ID: 2
Preference: 100 Cost: 2
NextHop: 192.168.3.2 Interface: GigabitEthernet4/1/1
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 0.0.0.0 Neighbor : 192.168.3.2
Tunnel ID: 0x0 Label: NULL
State: Inactive Adv Age: 00h03m57s
Tag: 0
# Enable RIP event debugging on Router A.
debugging rip 1 event
terminal debugging
# When the link between Router B and Router C fails, Router A quickly detects the link state
change.
%Jan 19 10:41:51:203 2008 RouterA BFD/4/LOG:Sess[192.168.1.1/192.168.2.2, GE4/1/2,
Ctrl], Sta: UP->DOWN, Diag: 1
*Jan 19 10:41:51:203 2008 RouterA RM/6/RMDEBUG: RIP-BFD: Message Type Disable, Connect
Type Indirect-connect, Pkt Type Control, Src IP Address 192.168.1.1, Src IFIndex 4,
Nbr IP Address 192.168.2.2.
# Display the BFD information of Router A.