H3C Technologies H3C SR8800 - Manual (Page 58)

42
Task Command Remarks
Display RIP current status and
configuration information.
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Display all active routes in RIP
database.
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display RIP interface information.
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Display routing information about
a specified RIP process.
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Reset a RIP process. reset rip process-id process Available in user view
Clear the statistics of a RIP process. reset rip process-id statistics Available in user view
RIP configuration examples
Configuring RIP version
Network requirements
As shown in Figure 10 , enable RIPv2 on all interfaces on Router A and Router B.
Figure 10 Network diagram
Configuration procedure
1. Configure an IP address for each interface. (Details not shown)
2. Configure basic RIP functions:
# Configure Router A.
system-view
[RouterA] rip
[RouterA-rip-1] network 1.0.0.0
[RouterA-rip-1] network 2.0.0.0
[RouterA-rip-1] network 3.0.0.0
# Configure Router B.
system-view