Configuration procedure – H3C Technologies H3C SR8800 User Manual

Page 71

Figure 16 Network diagram

Configuration procedure

Configure RIP basic functions and enable static route redistribution into RIP so that Router A and

Router C have routes to send to each other:
# Configure Router A.

system-view

[RouterA] rip 1

[RouterA-rip-1] network 192.168.1.0

[RouterA-rip-1] peer 192.168.2.2

[RouterA-rip-1] undo validate-source-address

[RouterA-rip-1] import-route static

[RouterA-rip-1] quit

[RouterA] interface GigabitEthernet 4/1/2

[RouterA-GigabitEthernet4/1/2] rip bfd enable

[RouterA-GigabitEthernet4/1/2] quit

[RouterA] rip 2

[RouterA-rip-2] network 192.168.3.0

[RouterA-rip-2] quit

# Configure Router C.

system-view

[RouterC] rip 1

[RouterC-rip-1] network 192.168.2.0

[RouterC-rip-1] network 192.168.4.0

[RouterC-rip-1] peer 192.168.1.1

[RouterC-rip-1] undo validate-source-address

[RouterC-rip-1] import-route static

[RouterC-rip-1] quit

[RouterC] interface GigabitEthernet 4/1/1

[RouterC-GigabitEthernet4/1/1] rip bfd enable

[RouterC-GigabitEthernet4/1/1] quit

# Configure Router D.

system-view

[RouterC] rip 1

This manual is related to the following products: