H3C Technologies H3C SR8800 - Manual (Page 46)

30
• With RIPv1 configured, an interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts
and RIPv1 unicasts.
• With RIPv2 configured, a multicast interface sends RIPv2 multicasts and can receive RIPv2 unicasts,
broadcasts, and multicasts.
• With RIPv2 configured, a broadcast interface sends RIPv2 broadcasts and can receive RIPv1
unicasts, and broadcasts, and RIPv2 broadcasts, multicasts, and unicasts.
To configure a RIP version:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify a global RIP version. version { 1 | 2 }
Optional.
By default, if an interface has a RIP
version specified, the version takes
precedence over the global one. If
no RIP version is specified for an
interface, the interface can send
RIPv1 broadcasts, and receive
RIPv1 broadcasts, unicasts, RIPv2
broadcasts, multicasts and
unicasts.
4. Return to system view. quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Specify a RIP version for the
interface. rip version { 1 | 2 [ broadcast |
multicast ] }
Optional.
By default, if an interface has no
RIP version specified, the global
version takes effect. If no global RIP
version is specified, the interface
can send RIPv1 broadcasts, and
receive RIPv1 broadcasts, unicasts,
RIPv2 broadcasts, multicasts and
unicasts.
Configuring RIP route control
In complex networks, you must configure advanced RIP features.
Before you configure RIP routing feature, complete the following tasks:
• Configure IP addresses for interfaces, and make sure that all neighboring routers can communicate
with each other.
• Configure RIP basic functions.
Configuring an additional routing metric
An additional routing metric (hop count) can be added to the metric of an inbound or outbound RIP
route.