H3C Technologies H3C SR8800 - Manual (Page 302)

286
You can configure an IPsec policy for a RIPng process or interface. The IPsec policy configured for a
process applies to all packets in the process. The IPsec policy configured on an interface applies to
packets on the interface. If an interface and its process each have an IPsec policy configured, the
interface uses its own IPsec policy.
Configuration prerequisites
Before you apply an IPsec policy for RIPng, complete following tasks:
• Create an IPsec proposal.
• Create an IPsec policy.
For more information about IPsec policy configuration, see Security Configuration Guide.
Configuration procedure
To apply an IPsec policy in a process:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIPng view. ripng [ process-id ] N/A
3. Apply an IPsec policy in the
process.
enable ipsec-policy policy-name Not configured by default
To apply an IPsec policy on an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Apply an IPsec policy on the
interface.
ripng ipsec-policy policy-name Not configured by default
NOTE:
An IPsec policy used for RIPng can only be in manual mode. For more information, see Security
Configuration Guide.
Displaying and maintaining RIPng
Task Command Remarks
Display configuration information
of a RIPng process.
display ripng [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Display routes in the RIPng
database.
display ripng process-id database
[ | { begin | exclude | include }
regular-expression ]
Available in any view