H3C Technologies H3C SR8800 - Manual (Page 34)

18
Figure 4 Network diagram
Device Interface IP address Device Interface IP address
Router A GE3/1/1 12.1.1.1/24 Router B GE3/1/1 12.1.1.2/24
GE3/1/2 10.1.1.102/24 GE3/1/2 13.1.1.1/24
Router C GE3/1/1 10.1.1.100/24
GE3/1/2 13.1.1.2/24
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown)
2. Configure BFD:
# Configure static routes on Router A and enable BFD control packet mode for the static route
through the Layer 2 switch.
system-view
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] bfd min-transmit-interval 500
[RouterA-GigabitEthernet3/1/1] bfd min-receive-interval 500
[RouterA-GigabitEthernet3/1/1] bfd detect-multiplier 9
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] ip route-static 120.1.1.0 24 GigabitEthernet 3/1/1 12.1.1.2 bfd
control-packet
[RouterA] ip route-static 120.1.1.0 24 GigabitEthernet 3/1/2 10.1.1.100 preference
65
[RouterA] quit
# Configure static routes on Router B and enable BFD control packet mode for the static route
through the Layer 2 switch.
system-view
[RouterB] interface GigabitEthernet 3/1/1
[RouterB-GigabitEthernet3/1/1] bfd min-transmit-interval 500
[RouterB-GigabitEthernet3/1/1] bfd min-receive-interval 500
[RouterB-GigabitEthernet3/1/1] bfd detect-multiplier 9
[RouterB-GigabitEthernet3/1/1] quit
[RouterB] ip route-static 121.1.1.0 24 GigabitEthernet 3/1/1 12.1.1.1 bfd
control-packet
[RouterB] ip route-static 121.1.1.0 24 GigabitEthernet 3/1/2 13.1.1.2 preference 65
[RouterB] quit
3. Verify the configuration:
The following operations are performed on Router A. The operations on Router B are similar.
display bfd session
Router A Router B
GE3/1/1
Router C
BFD
L 2 Switch
121.1.1.0/ 24 120.1.1.0/24
GE3/1/1
GE3/1/2 GE3/1/2
GE3/1/1 GE3/1/2