Configuration procedure – H3C Technologies H3C SR8800 User Manual

Page 335

319

Figure 111 Network diagram

Configuration procedure

Configure IPv6 addresses for interfaces. (Details not shown)

Configure OSPFv3 basic functions:
# Enable OSPFv3 process 1 on Router A.

system-view

[RouterA] ipv6

[RouterA] ospfv3 1

[RouterA-ospfv3-1] router-id 1.1.1.1

[RouterA-ospfv3-1] quit

[RouterA] interface GigabitEthernet 3/1/2

[RouterA-GigabitEthernet3/1/2] ospfv3 1 area 2

[RouterA-GigabitEthernet3/1/2] quit

[RouterA] interface GigabitEthernet 3/1/1

[RouterA-GigabitEthernet3/1/1] ospfv3 1 area 2

[RouterA-GigabitEthernet3/1/1] quit

# Enable OSPFv3 process 1 and OSPFv3 process 2 on Router B.

system-view

[RouterB] ipv6

[RouterB] ospfv3 1

[RouterB-ospfv3-1] router-id 2.2.2.2

[RouterB-ospfv3-1] quit

[RouterB] interface GigabitEthernet 3/1/2

[RouterB-GigabitEthernet3/1/2] ospfv3 1 area 2

[RouterB-GigabitEthernet3/1/2] quit

[RouterB] ospfv3 2

[RouterB-ospfv3-2] router-id 3.3.3.3

[RouterB-ospfv3-2] quit

[RouterB] interface GigabitEthernet 3/1/1

[RouterB-GigabitEthernet3/1/1] ospfv3 2 area 2

[RouterB-GigabitEthernet3/1/1] quit

# Enable OSPFv3 process 2 on Router C.

system-view

[RouterC] ipv6

[RouterC] ospfv3 2

[RouterC-ospfv3-2] router-id 4.4.4.4

[RouterC-ospfv3-2] quit

This manual is related to the following products: