H3C Technologies H3C SR8800 User Manual
Page 151
135
2.
Use the display ospf interface command to display OSPF interface information.
3.
Use the display ospf lsdb command to display the Link State Database to check its integrity.
4.
Display information about area configuration using the display current-configuration
configuration ospf command. If more than two areas are configured, at least one area is
connected to the backbone.
5.
In a Stub area, all routers attached are configured with the stub command. In an NSSA area, all
routers attached are configured with the nssa command.
6.
If a virtual link is configured, use the display ospf vlink command to check the state of the virtual
link.
This manual is related to the following products:
- H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module