Configuration procedure – H3C Technologies H3C SR8800 User Manual

Page 140

124

Figure 45 Network diagram

Configuration procedure

Configure IP address for interfaces. (Details not shown)

Configure OSPF basic functions:
# Configure Router A

system-view

[RouterA] router id 1.1.1.1

[RouterA] ospf 100

[RouterA-ospf-100] enable link-local-signaling

[RouterA-ospf-100] enable out-of-band-resynchronization

[RouterA-ospf-100] graceful-restart

[RouterA-ospf-100] area 0

[RouterA-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255

[RouterA-ospf-100-area-0.0.0.0] quit

# Configure Router B

system-view

[RouterB] router id 2.2.2.2

[RouterB] ospf 100

[RouterB-ospf-100] area 0

[RouterB-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255

[RouterB-ospf-100-area-0.0.0.0] quit

# Configure Router C

system-view

[RouterC] router id 3.3.3.3

[RouterC] ospf 100

[RouterC-ospf-100] area 0

[RouterC-ospf-100-area-0.0.0.0] network 192.1.1.0 0.0.0.255

[RouterC-ospf-100-area-0.0.0.0] quit

Configure OSPF GR:
# Configure Router A as the non-IETF standard OSPF GR Restarter: enable the link-local signaling
capability, the out-of-band re-synchronization capability, and non IETF standard Graceful Restart

capability for OSPF process 100.

[RouterA-ospf-100] enable link-local-signaling

[RouterA-ospf-100] enable out-of-band-resynchronization

[RouterA-ospf-100] graceful-restart

This manual is related to the following products:

H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module