H3C Technologies H3C SR8800 - Manual (Page 326)

310
Step Command Remarks
4. Apply an IPsec policy in the
area.
enable ipsec-policy policy-name Not configured by default
To apply an IPsec policy on an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Apply an IPsec policy on the
interface.
ospfv3 ipsec-policy policy-name
[ instance instance-id ]
Not configured by default
To apply an IPsec policy on a virtual link:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view. ospfv3 [ process-id ] N/A
3. Enter OSPF area view. area area-id N/A
4. Apply an IPsec policy on a
virtual link.
vlink-peer router-id [ hello seconds |
retransmit seconds | trans-delay
seconds | dead seconds | instance
instance-id | ipsec-policy policy-name ]
*
Not configured by default
NOTE:
An IPsec policy used for OSPFv3 can only be in manual mode. For more information, see Security
Configuration Guide.
Displaying and maintaining OSPFv3
Task Command Remarks
Display OSPFv3 process brief
information. display ospfv3 [ process-id ] [ | { begin | exclude |
include } regular-expression ] Available in
any view
Display OSPFv3 interface
information.
display ospfv3 interface [ interface-type
interface-number | statistic ] [ | { begin | exclude |
include } regular-expression ]
Available in
any view
Display OSPFv3 LSDB information.
display ospfv3 [ process-id ] lsdb [ [ external |
inter-prefix | inter-router | intra-prefix | link | network
| router | grace ] [ link-state-id ] [ originate-router
router-id ] | total ] [ | { begin | exclude | include }
regular-expression ]
Available in
any view
Display OSPFv3 LSDB statistics.
display ospfv3 lsdb statistic [ | { begin | exclude |
include } regular-expression ] Available in
any view