H3C Technologies H3C SR8800 - Manual (Page 105)

89
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value
Optional.
The value defaults to 100
Mbps.
Configuring the maximum number of OSPF routes
To configure the maximum number of routes:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the maximum
number of OSPF routes. maximum-routes { external | inter | intra }
number
Optional
Configuring the maximum number of load-balanced routes
If several equal-cost routes to the same destination are available, you can configure them as
load-balanced routes to improve link utilization.
To configure the maximum number of load-balanced routes:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the maximum
number of load-balanced
routes.
maximum load-balancing maximum Optional
Configuring OSPF preference
A router may run multiple routing protocols, and each protocol is assigned a preference. When the
routing protocols find routes to the same destination, the route found by the protocol with the highest
preference is selected as the best route.
To configure OSPF preference:
Step Command Remarks
1. Enter system view. system-view N/A