H3C Technologies H3C SR8800 - Manual (Page 363)

347
Step Command Remarks
3. Enter IPv6 address family view. ipv6-family N/A
4. Allow the establishment of EBGP
connection to a non directly connected
peer/peer group.
peer { ipv6-group-name |
ipv6-address } ebgp-max-hop
[ hop-count ]
Not configured by
default
NOTE:
In general, direct links should be available between EBGP peers. If not, you can use the peer
ebgp-max-hop command to establish a multi-hop TCP connection in between. However, you need not use
this command for direct EBGP connections with loopback interfaces.
Configuring a description for an IPv6 peer/peer group
To configure description for an IPv6 peer/peer group:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure a description for an
IPv6 peer/peer group. peer { ipv6-group-name | ipv6-address }
description description-text Optional
Not configured by default
NOTE:
The peer group to be configured with a description must have been created.
Disabling session establishment to an IPv6 peer/peer group
To disable session establishment to a peer/peer group:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view. ipv6-family N/A
4. Disable session establishment to an
IPv6 peer/peer group. peer { ipv6-group-name |
ipv6-address } ignore
Optional
Not disabled by default
Logging IPv6 peer/peer group state changes
To configure to log on the session and event information of an IPv6 peer/peer group: