H3C Technologies H3C SR8800 - Manual (Page 114)

98
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable the logging of
neighbor state changes.
log-peer-change
Optional
Enabled by default
Configuring OSPF network management
With trap generation enabled, OSPF generates traps to report important events. Traps fall into the
following levels.
• Level-3—Fault traps
• Level-4—Alarm traps
• Level-5—Normal but important traps
• Level-6—Notification traps
The generated traps are sent to the information center of the router. The output rules of the traps such as
whether to output the traps and the output direction are determined according to the information center
configuration. (For information center configuration, see Network Management and Monitoring
Configuration Guide.)
To configure OSPF network management:
Step Command Remarks
1. Enter system view. system-view N/A
2. Bind OSPF MIB to an
OSPF process.
ospf mib-binding process-id
Optional.
The OSPF process with the smallest
process-id is bound with OSPF MIB
by default.
3. Enable OSPF trap
generation.
snmp-agent trap enable ospf [ process-id ]
[ ifauthfail | ifcfgerror | ifrxbadpkt |
ifstatechange | iftxretransmit |
lsdbapproachoverflow | lsdboverflow |
maxagelsa | nbrstatechange | originatelsa
| vifcfgerror | virifauthfail | virifrxbadpkt
| virifstatechange | viriftxretransmit |
virnbrstatechange ] *
Optional.
Enabled by default.
Enabling message logging
To enable message logging:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A