H3C Technologies H3C SR8800 - Manual (Page 115)

99
Step Command Remarks
3. Enable message
logging.
enable log [ config | error | state ] Not enabled by default
Enabling the advertisement and reception of opaque LSAs
With this feature enabled, OSPF can receive and advertise Type 9, Type 10, and Type 11 opaque LSAs.
To enable the advertisement and reception of opaque LSAs:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable the advertisement and
reception of opaque LSAs.
opaque-capability enable
Optional
Disabled by default
Configuring OSPF to give priority to receiving and processing
hello packets
To ensure OSPF runs properly, a router receives and processes Hello packets and other protocol packets
at the same time. When the router has established neighbor relationships with multiple routers and the
routing table size is big, the router needs to receive and process large numbers of packets. In this case,
you can configure OSPF to give priority to receiving and processing Hello packets to ensure stable
neighbor relationships.
To configure OSPF to give priority to receiving and processing Hello packets:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure OSPF to
give priority to
receiving and
processing Hello
packets.
ospf packet-process prioritized-treatment Not configured by default
Configuring the LSU transmit rate
Sending large numbers of LSU packets affects router performance and consumes too much network
bandwidth. You can configure the router to send LSU packets at a proper interval and limit the maximum
number of LSU packets sent out of an OSPF interface each time.
To configure the LSU transmit rate:
Step Command Remarks
1. Enter system view. system-view N/A