H3C Technologies H3C SR8800 - Manual (Page 371)

355
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view. ipv6-family N/A
4. Configure IPv6 BGP timers.
• Specify keepalive interval
and holdtime:
timer keepalive keepalive
hold holdtime
• Configure keepalive
interval and holdtime for an
IPv6 peer/peer group:
peer { ipv6-group-name |
ipv6-address } timer
keepalive keepalive hold
holdtime
Optional.
The keepalive interval defaults to
60 seconds, holdtime defaults to
180 seconds.
5. Configure the interval for sending
the same update to an IPv6
peer/peer group.
peer { ipv6-group-name |
ipv6-address }
route-update-interval interval
Optional.
The interval for sending the same
update to an IBGP peer or an
EBGP peer defaults to 15
seconds or 30 seconds.
NOTE:
•
Timers configured using the timer command have lower priority than timers configured using the peer
timer command.
• The holdtime interval must be at least three times the keepalive interval.
Configuring IPv6 BGP soft reset
Enabling route refresh
To enable route refresh:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address
family view.
ipv6-family N/A
4. Enable route refresh.
peer { ipv6-group-name | ipv6-address }
capability-advertise route-refresh
Optional
Enabled by default
Performing manual soft-reset
To perform manual soft reset:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A