H3C Technologies H3C SR8800 - Manual (Page 429)

413
Verifying the configuration
After you complete the configuration, verify that when Router A receives packets with destination IP
address 201.1.1.2, it forwards the packets to Router C instead of Router B.
IPv6 QoS policy routing configuration example
Network requirements
As shown in Figure 129 , redirect all packets received on GigabitEthernet 3/1/1 of Router A to the next
hop 202::2.
Figure 129 Network diagram
Configuration procedure
# Configure IPv6 ACL 2000.
system-view
[RouterA] acl ipv6 number 2000
[RouterA-acl6-basic-2000] rule 0 permit source any
[RouterA-acl6-basic-2000] quit
# Define a match criterion for class a to match IPv6 ACL 2000.
[RouterA] traffic classifier a
[RouterA-classifier-a] if-match acl ipv6 2000
[RouterA-classifier-a] quit
# Configure the action of redirecting traffic to the next hop 202::2 for behavior a.
[RouterA] traffic behavior a
[RouterA-behavior-a] redirect next-hop 202::2
[RouterA-behavior-a] quit
# Associate class a with behavior a in QoS policy a.
[RouterA] qos policy a
[RouterA-qospolicy-a] classifier a behavior a
[RouterA-qospolicy-a] quit
# Apply QoS policy a to the inbound direction of GigabitEthernet 3/1/1.
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] qos apply policy a inbound
Verifying the configuration
After completing the configuration, verify that when Router A receives packets with destination IP address
201::2, it forwards the packets to Router C instead of Router B.