H3C Technologies H3C SR8800 - Manual (Page 122)

106
Task Command Remarks
Reset OSPF counters.
reset ospf [ process-id ] counters [ neighbor
[ interface-type interface-number ] [ router-id ] ] Available in user
view
Reset an OSPF process. reset ospf [ process-id ] process [ graceful-restart ]
Available in any
view
Re-enable OSPF route
redistribution.
reset ospf [ process-id ] redistribution
Available in any
view
OSPF configuration examples
NOTE:
These examples only cover OSPF configuration related commands.
Configuring OSPF basic functions
Network requirements
• As shown in Figure 38 , all routers run OSPF. The AS is split into three areas, in which, Router A and
Router B act as ABRs.
• After configuration, all routers can learn routes to every network segment in the AS.
Figure 38 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown)
2. Configure OSPF basic functions:
# Configure Router A.
system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit
[RouterA-ospf-1] area 1
[RouterA-ospf-1-area-0.0.0.1] network 10.2.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.1] quit