H3C Technologies H3C SR8800 - Manual (Page 303)

287
Task Command Remarks
Display the routing information of
a specified RIPng process.
display ripng process-id route [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display RIPng interface
information.
display ripng process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view
Reset a RIPng process. reset ripng process-id process Available in user view
Clear statistics of a RIPng process. reset ripng process-id statistics Available in user view
RIPng configuration examples
Configuring RIPng basic functions
Network requirements
As shown in Figure 105 , all routers learn IPv6 routing information through RIPng. Configure Router B to
filter the route (3::/64) learned from Router C, which means the route will not be added to the routing
table of Router B, and Router B will not forward it to Router A.
Figure 105 Network diagram
Configuration procedure
1. Configure the IPv6 address for each interface. (Details not shown)
2. Configure basic RIPng functions:
# Configure Router A.
system-view
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface GigabitEthernet 1/1/1
[RouterA-GigabitEthernet1/1/1] ripng 1 enable
[RouterA-GigabitEthernet1/1/1] quit
[RouterA] interface GigabitEthernet 1/1/2
[RouterA-GigabitEthernet1/1/2] ripng 1 enable
[RouterA-GigabitEthernet1/1/2] quit
# Configure Router B.
system-view
[RouterB] ripng 1
[RouterB-ripng-1] quit
GE1/1 /1
1::2 /64 GE 1/1 /1
3::2/64
GE1/1/2
5::1/64 GE 1/1 /2
3::1/64
GE1 /1/3
4::1 /64
GE1/1/2
2::1/64
GE 1/1/1
1::1/64
Router A Router B Router C
RIPng