H3C Technologies H3C SR8800 - Manual (Page 339)

323
[RouterC-GigabitEthernet 3/1/1] quit
3. Verify the configuration;
# After all routers function properly, perform a master/backup switchover on Router A to trigger a
OSPFv3 GR operation.
Configuring BFD for OSPFv3
Network requirements
As shown in Figure 113 :
• Configure OSPFv3 on Router A, Router B and Router C and configure BFD over the link Router
A<—>L2 Switch<—>Router B.
• After the link Router A<—>L2 Switch<—>Router B fails, BFD can quickly detect the failure and
notify OSPFv3 of the failure. Then Router A and Router B communicate through Router C.
Figure 113 Network diagram
Device Interface IPv6 address Device Interface IPv6 address
Router A GE3/1/1 2001::1/64 Router B GE3/1/1 2001::2/64
GE3/1/2 2001:2::1/64 GE3/1/2 2001:3::2/64
Router C GE3/1/1 2001:2::2/64
GE3/1/2 2001:3::1/64
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown)
2. Configure OSPF basic functions:
# Configure Router A. Enable OSPFv3 and configure the router ID as 1.1.1.1.
system-view
[RouterA] ipv6
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] ospfv3 1 area 0
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] interface GigabitEthernet 3/1/2
[RouterA-GigabitEthernet3/1/2] ospfv3 1 area 0
Router A Router B
BFD
L 2 Switch
Area 0
Router C
2001:4 ::0/ 64 2001:1 ::0/ 64
GE3/1/1
GE3/1/2
GE3/1/1
GE3/1/2
GE3/1/2 GE3/1/1