H3C Technologies H3C SR8800 - Manual (Page 428)

412
NOTE:
•
QoS policies cannot be applied to dynamic VLANs, for example, VLANs created by GVRP.
• You can apply the QoS policy globally only on SPC cards.
QoS policy routing configuration examples
IPv4 QoS policy routing configuration example
Network requirements
As shown in Figure 128 , redirect all packets received on GigabitEthernet 3/1/1 of Router A to the next
hop 202.1.1.2.
Figure 128 Network diagram
Configuration procedure
# Configure ACL 2000.
system-view
[RouterA] acl number 2000
[RouterA-acl-basic-2000] rule 0 permit source any
[RouterA-acl-basic-2000] quit
# Define a match criterion for class a to match ACL 2000.
[RouterA] traffic classifier a
[RouterA-classifier-a] if-match acl 2000
[RouterA-classifier-a] quit
# Configure the action of redirecting traffic to the next hop 202.1.1.2 for behavior a.
[RouterA] traffic behavior a
[RouterA-behavior-a] redirect next-hop 202.1.1.2
[RouterA-behavior-a] quit
# Associate class a with behavior a in QoS policy a.
[RouterA] qos policy a
[RouterA-qospolicy-a] classifier a behavior a
[RouterA-qospolicy-a] quit
# Apply QoS policy a to the inbound direction of GigabitEthernet 3/1/1.
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] qos apply policy a inbound