H3C Technologies H3C SR8800 - Manual (Page 30)

14
Figure 2 Network diagram
Configuration procedure
1. Configuring IP addresses for interfaces. (Details not shown)
2. Configuring static routes:
# Configure a default route on Router A.
system-view
[RouterA] ip route-static 0.0.0.0 0.0.0.0 1.1.4.2
# Configure two static routes on Router B.
system-view
[RouterB] ip route-static 1.1.2.0 255.255.255.0 1.1.4.1
[RouterB] ip route-static 1.1.3.0 255.255.255.0 1.1.5.6
# Configure a default route on Router C.
system-view
[RouterC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
3. Configure the hosts:
The default gateways for Host A, Host B and Host C are 1.1.2.3, 1.1.6.1 and 1.1.3.1
respectively. The configuration procedure is not shown.
4. Verify the configuration:
# Display the IP routing table of Router A.
[RouterA] display ip routing-table
Routing Tables: Public
Destinations : 7 Routes : 7
Destination/Mask Proto Pre Cost NextHop Interface
0.0.0.0/0 Static 60 0 1.1.4.2 GE1/1/2
1.1.2.0/24 Direct 0 0 1.1.2.3 GE1/1/1
1.1.2.3/32 Direct 0 0 127.0.0.1 InLoop0
1.1.4.0/30 Direct 0 0 1.1.4.1 GE1/1/2
1.1.4.1/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0