H3C Technologies H3C SR8800 - Manual (Page 313)

297
LSA delay timer
Each LSA has an age in the local LSDB (incremented by 1 per second), but an LSA does not age on
transmission. You must add an LSA delay time into the age time before transmission, which is important
for low-speed networks.
SPF timer
Whenever the LSDB changes, an SPF calculation happens. If recalculations become more frequent, a
large amount of resources will be occupied. You can adjust the SPF calculation interval and delay time
to protect networks from being overloaded due to frequent changes.
GR timer
If a failure to establish adjacencies occurs during a GR, the router will be in the GR process for a long
time. To avoid this, you can configure the GR timer for the router to exit the GR process when the timer
expires.
OSPFv3 features supported
• Basic features defined in RFC 2740
• OSPFv3 stub area
• OSPFv3 multi-process
• VPN instances
• OSPFv3 GR
• BFD
Protocols and standards
• RFC 2740, OSPF for IPv6
• RFC 2328, OSPF Version 2
• RFC 5187, OSPFv3 Graceful Restart
OSPFv3 configuration task list
Complete the following tasks to configure OSPFv3:
Task Remarks
Enabling OSPFv3 Required
Configuring OSPFv3 area
parameters
Configuring an OSPFv3 stub area Optional
Configuring an OSPFv3 virtual link Optional
Configuring OSPFv3 network
types
Configuring the OSPFv3 network type for an
interface
Optional
Configuring an NBMA or P2MP neighbor Optional
Configuring OSPFv3 routing
information control
Configuring OSPFv3 route summarization Optional
Configuring OSPFv3 inbound route filtering Optional
Configuring an OSPFv3 cost for an interface Optional