H3C Technologies H3C SR8800 - Manual (Page 332)

316
Figure 110 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown)
2. Configure OSPFv3 basic functions:
# Configure Router A.
system-view
[RouterA] ipv6
[RouterA] ospfv3
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface GigabitEthernet 1/1/1
[RouterA-GigabitEthernet1/1/1] ospfv3 1 area 0
[RouterA-GigabitEthernet1/1/1] quit
# Configure Router B.
system-view
[RouterB] ipv6
[RouterB] ospfv3
[RouterB-ospfv3-1] router-id 2.2.2.2
[RouterB-ospfv3-1] quit
[RouterB] interface GigabitEthernet 1/1/1
[RouterB-GigabitEthernet1/1/1] ospfv3 1 area 0
[RouterB-GigabitEthernet1/1/1] quit
# Configure Router C.
system-view
[RouterC] ipv6
[RouterC] ospfv3
[RouterC-ospfv3-1] router-id 3.3.3.3
[RouterC-ospfv3-1] quit
[RouterC] interface GigabitEthernet 1/1/1
[RouterC-GigabitEthernet1/1/1] ospfv3 1 area 0
[RouterC-GigabitEthernet1/1/1] quit
# Configure Router D.
system-view
Router A
Router C
Router B
Router D
GE1/1/1
2001 ::1/64
GE1 /1/1
2001 ::2/64
GE 1/1 /1
2001 ::3/64 GE1/1/1
2001::4/64