H3C Technologies H3C SR8800 - Manual (Page 376)

360
Step Command Remarks
5. Add a peer into the group.
peer ipv6-address group
ipv6-group-name [ as-number
as-number ]
Not added by default
Creating a pure EBGP peer group
To configure a pure EBGP group:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Create an EBGP peer group. group ipv6-group-name external N/A
5. Configure the AS number for
the peer group. peer ipv6-group-name as-number
as-number
Not configured by default
6. Add an IPv6 peer into the
peer group. peer ipv6-address group
ipv6-group-name
Not added by default
NOTE:
•
To create a pure EBGP peer group, you must specify an AS number for the peer group.
• If a peer was added into an EBGP peer group, you cannot specify any AS number for the peer group.
Creating a mixed EBGP peer group
To create a mixed EBGP peer group:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Create an EBGP peer group. group ipv6-group-name external N/A
5. Specify the AS number of an
IPv6 peer. peer ipv6-address as-number
as-number
Not specified by default
6. Add the IPv6 peer into the
peer group. peer ipv6-address group
ipv6-group-name
Not added by default
NOTE:
When creating a mixed EBGP peer group, you must create a peer and specify its AS number that can be
different from AS numbers of other peers; however, you cannot specify AS number for the EBGP peer
group.