H3C Technologies H3C SR8800 - Manual (Page 407)

391
Figure 124 Network diagram
Configuration procedure
NOTE:
In this example, RIPng is configured to ensure the reachability among routers.
1. Configure Router A:
# Configure RIPng.
system-view
[RouterA] ipv6
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface Serial 2/1/9/2:0
[RouterA-Serial2/1/9/2:0] ipv6 address 1::1 64
[RouterA-Serial2/1/9/2:0] ripng 1 enable
[RouterA-Serial2/1/9/2:0] quit
[RouterA] interface Serial 2/1/9/1:0
[RouterA-Serial2/1/9/1:0] ipv6 address 2::1 64
[RouterA-Serial2/1/9/1:0] ripng 1 enable
[RouterA-Serial2/1/9/1:0] quit
# Define ACL 3001 to match TCP packets.
[RouterA] acl ipv6 number 3001
[RouterA-acl6-adv-3001] rule permit tcp
[RouterA-acl6-adv-3001] quit
# Define Node 5 of policy aaa, so that TCP packets are forwarded via next hop 1::2.
[RouterA] ipv6 policy-based-route aaa permit node 5
[RouterA-pbr-aaa-5] if-match acl6 3001
[RouterA-pbr-aaa-5] apply ipv6-address next-hop 1::2
Router A
GE3/1/1
10::2/64
S2/1/9/2:0
1::1/64
S2/1/9/1:0
2::1/64
Subnet A
10::1/64
S3/1/9/2:0
1::2/64
S3/1/9/1:0
2::2/64
Router B Router C
Host A
10::3