H3C Technologies H3C SR8800 - Manual (Page 361)

345
• Specify IP addresses for interfaces.
• Enable IPv6 with the ipv6 command in system view.
NOTE:
Create a peer group before you configure basic functions for it. For related information, see “ Configuring
IPv6 BGP peer group .”
Specifying an IPv6 BGP peer
To configure an IPv6 BGP peer:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Specify a router ID. router-id router-id
Optional.
Required if no IP addresses are
configured for any interfaces.
4. Enter IPv6 address family
view.
ipv6-family N/A
5. Specify an IPv6 peer.
peer ipv6-address as-number
as-number
N/A
Injecting a local IPv6 route
To configure advertise a local route into the routing table:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Inject a local route into the
IPv6 BGP routing table.
network ipv6-address prefix-length
[ short-cut | route-policy
route-policy-name ]
Not added by default
Configuring a preferred value for routes from a peer/peer
group
To configure a preferred value for routes received from a peer/peer group:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A