H3C Technologies H3C SR8800 User Manual
Page 242
226
•
If the holdtime settings on the local and peer routers are different, the smaller one is used.
•
If the keepalive interval is 0 and the negotiated holdtime is not 0, the actual keepalive interval
equals one-third of the holdtime.
•
If the keepalive interval is not 0, the actual keepalive interval is the smaller one between one third
of the holdtime and the keepalive interval.
To configure BGP keepalive interval and holdtime:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Configure BGP keepalive interval
and holdtime.
•
Configure the global keepalive
interval and holdtime:
timer keepalive keepalive hold
holdtime
•
Configure the keepalive interval
and holdtime for a peer/peer
group:
peer { group-name |
ip-address } timer keepalive
keepalive hold holdtime
Optional.
By default, the keepalive
interval is 60 seconds, and
holdtime is 180 seconds.
NOTE:
•
The maximum keepalive interval should be one third of the holdtime and no less than 1 second. The
holdtime is no less than 3 seconds unless it is set to 0.
•
The intervals set with the peer timer command are preferred to those set with the timer command.
•
If the router has established a neighbor relationship with a peer, you must reset the BGP connection to
validate the new set timers.
•
The timer command takes effect for only new connections.
•
After peer timer command is executed, the peer connection is closed at once, and a new connection to
the peer is negotiated using the configured hold time.
Configuring the interval for sending the same update
To configure the interval for sending the same update to a peer/peer group:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp as-number
N/A
3.
Configure the interval for sending the
same update to a peer/peer group.
peer { group-name | ip-address }
route-update-interval interval
Optional.
The intervals for sending the
same update to an IBGP
peer and an EBGP peer
default to 15 seconds and
30 seconds respectively.
- H3C SR6600-X H3C SR6600 H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C WX3000 Series Unified Switches H3C LSWM1WCM10 Access Controller Module H3C LSWM1WCM20 Access Controller Module H3C LSQM1WCMB0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module H3C LSBM1WCM2A0 Access Controller Module