H3C Technologies H3C SR8800 - Manual (Page 319)

303
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an OSPFv3
cost for the interface. ospfv3 cost value [ instance
instance-id ]
Optional.
By default, OSPFv3 computes an interface’s
cost according to its bandwidth.
The cost value defaults to 1 for VLAN interfaces
and defaults to 0 for loopback interfaces.
To configure a bandwidth reference value:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view. ospfv3 [ process-id ] N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value
Optional
100 Mbps by default
Configuring the maximum number of OSPFv3 load-balanced
routes
If multiple equal-cost routes to a destination are available, enabling load balancing among these routes
can improve link utilization.
To configure the maximum number of load-balanced routes:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view. ospfv3 [ process-id ] N/A
3. Specify the maximum number
of load-balanced routes. maximum load-balancing
maximum
Optional
Configuring a priority for OSPFv3
A router may run multiple routing protocols. The system assigns a priority for each protocol. When these
routing protocols find the same route, the route found by the protocol with the highest priority is selected.
To configure a priority for OSPFv3:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPFv3 view. ospfv3 [ process-id ] N/A