H3C Technologies H3C SR8800 - Manual (Page 327)

311
Task Command Remarks
Display OSPFv3 neighbor
information.
display ospfv3 [ process-id ] [ area area-id ] peer
[ [ interface-type interface-number ] [ verbose ] |
peer-router-id ] [ | { begin | exclude | include }
regular-expression ]
Available in
any view
Display OSPFv3 neighbor statistics.
display ospfv3 peer statistic [ | { begin | exclude |
include } regular-expression ] Available in
any view
Display OSPFv3 routing table
information.
display ospfv3 [ process-id ] routing [ ipv6-address
prefix-length | ipv6-address/prefix-length | abr-routes
| asbr-routes | all | statistics ] [ | { begin | exclude |
include } regular-expression ]
Available in
any view
Display OSPFv3 area topology
information. display ospfv3 [ process-id ] topology [ area area-id ] [ |
{ begin | exclude | include } regular-expression ] Available in
any view
Display OSPFv3 virtual link
information. display ospfv3 [ process-id ] vlink [ | { begin | exclude
| include } regular-expression ] Available in
any view
Display OSPFv3 next hop
information. display ospfv3 [ process-id ] next-hop [ | { begin |
exclude | include } regular-expression ] Available in
any view
Display OSPFv3 link state request
list information.
display ospfv3 [ process-id ] request-list [ { external |
inter-prefix | inter-router | intra-prefix | link | network
| router | grace } [ link-state-id ] [ originate-router
ip-address ] | statistics ] [ | { begin | exclude | include }
regular-expression ]
Available in
any view
Display OSPFv3 link state
retransmission list information.
display ospfv3 [ process-id ] retrans-list [ { external |
inter-prefix | inter-router | intra-prefix | link | network
| router | grace } [ link-state-id ] [ originate-router
ip-address ] | statistics ] [ | { begin | exclude | include }
regular-expression ]
Available in
any view
Display OSPFv3 statistics.
display ospfv3 statistic [ | { begin | exclude | include }
regular-expression ] Available in
any view
Display the GR status of the
specified OSPFv3 process. display ospfv3 [ process-id ] graceful-restart status [ |
{ begin | exclude | include } regular-expression ] Available in
any view
OSPFv3 configuration examples
Configuring OSPFv3 areas
Network requirements
In Figure 110 , all routers run OSPFv3. The AS is split into three areas, in which, Router B and Router C act
as ABRs to forward routing information between areas.
You are required to configure Area 2 as a stub area in order to reduce LSAs in the area without affecting
route reachability.