H3C Technologies H3C SR8800 - Manual (Page 288)

272
Figure 100 Network diagram
Configuration procedure
NOTE:
In this example, static routes are configured to ensure the reachability among routers.
1. Configure Router A:
# Define ACL 3101 to match TCP packets.
system-view
[RouterA] acl number 3101
[RouterA-acl-adv-3101] rule permit tcp
[RouterA-acl-adv-3101] quit
# Define Node 5 of policy aaa so that TCP packets are forwarded via next hop 1.1.2.2.
[RouterA] policy-based-route aaa permit node 5
[RouterA-pbr-aaa-5] if-match acl 3101
[RouterA-pbr-aaa-5] apply ip-address next-hop 1.1.2.2
[RouterA-pbr-aaa-5] quit
# Apply the policy aaa to GigabitEthernet 3/1/1.
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] ip address 10.110.0.10 255.255.255.0
[RouterA-GigabitEthernet3/1/1] ip policy-based-route aaa
[RouterA-GigabitEthernet3/1/1] quit
# Configure the IP addresses of the serial ports.
[RouterA] interface Serial 2/1/9/2:0
[RouterA-Serial2/1/9/2:0] ip address 1.1.2.1 255.255.255.0
[RouterA-Serial2/1/9/2:0] quit
[RouterA] interface Serial 2/1/9/1:0