H3C Technologies H3C SR8800 - Manual (Page 390)

374
4. Configure CE 2:
# Enable IPv6 packet forwarding and specify IP addresses for interfaces.
system-view
[CE2] ipv6
[CE2] interface Pos 2/1/2
[CE2-Pos2/1/2] ipv6 address auto link-local
[CE2-Pos2/1/2] quit
[CE2] interface loopback 0
[CE2-LoopBack0] ipv6 address 4::4/128
[CE2-LoopBack0] quit
# Configure the static route to PE 2.
[CE2] ipv6 route-static :: 0 Pos2/1/2
5. Verify the configuration:
# Display MPLS LSP information on PE 1.
display mpls lsp
--------------------------------------------------------------
LSP Information: BGP IPV6 LSP
--------------------------------------------------------------
FEC : 1::1
In Label : 1024 Out Label : -----
In Interface : ----- OutInterface : -----
Vrf Name :
FEC : 2::2
In Label : 1025 Out Label : -----
In Interface : ----- OutInterface : -----
Vrf Name :
---------------------------------------------------------------
LSP Information: LDP LSP
---------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.3/32 NULL/3 -/S4/1/9:0
2.2.2.2/32 3/NULL S4/1/9:0/-
# Display the IPv6 BGP routing table on PE 1.
display bgp ipv6 routing-table
Total Number of Routes: 4
BGP Local router ID is 2.2.2.2
Status codes: * - valid, ^ - VPNv4 best, > - best, d - damped,
h - history, i - internal, s - suppressed, S – Stale
Origin : i - IGP, e - EGP, ? - incomplete
*> Network : 1::1 PrefixLen : 128
NextHop : FE80::E142:0:4607:1 LocPrf :
PrefVal : 0 Label : NULL
MED : 0
Path/Ogn: ?