H3C Technologies H3C SR8800 - Manual (Page 167)

151
• RFC 3373, Three-Way Handshake for IS-IS Point-to-Point Adjacencies
• RFC 3567, Intermediate System to Intermediate System (IS-IS) Cryptographic Authentication
• RFC 3719, Recommendations for Interoperable Networks using IS-IS
• RFC 3786, Extending the Number of IS-IS LSP Fragments Beyond the 256 Limit
• RFC 3787, Recommendations for Interoperable IP Networks using IS-IS
• RFC 3784, IS-IS extensions for Traffic Engineering
• RFC 3847, Restart signaling for IS-IS
IS-IS configuration task list
Complete the following tasks to configure IS-IS:
Task Remarks
Configuring IS-IS
basic functions
Enabling IS-IS Required
Configuring the IS level and circuit level Required
Configuring the network type of an interface as P2P Required
Configuring IS-IS
routing information
control
Configuring IS-IS link cost Optional
Specifying a priority for IS-IS Required
Configuring the maximum number of equal cost routes Optional
Configuring IS-IS route summarization Optional
Advertising a default route Optional
Configuring IS-IS route redistribution Optional
Configuring IS-IS route filtering Optional
Configuring IS-IS route leaking Optional
Tuning and
optimizing IS-IS
networks
Specifying intervals for sending IS-IS hello and CSNP packets Optional
Specifying the IS-IS hello multiplier Optional
Configuring a DIS priority for an interface Optional
Disabling an interface from sending/receiving IS-IS packets Optional
Disabling hello source address check for a PPP interface Optional
Enabling an interface to send small hello packets Optional
Configuring LSP parameters Optional
Configuring SPF parameters Optional
Setting the LSDB overload bit Optional
Configuring system ID to host name mappings Optional
Enabling the logging of neighbor state changes Optional
Enhancing IS-IS
network security
Configuring neighbor relationship authentication Optional
Configuring area authentication Optional
Configuring routing domain authentication Optional