H3C Technologies H3C SR8800 - Manual (Page 54)

38
Step Command Remarks
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify a RIP neighbor. peer ip-address N/A
4. Disable source address check
on incoming RIP updates.
undo validate-source-address Not disabled by default
NOTE:
•
You need not use the peer ip-address command when the neighbor is directly connected; otherwise the
neighbor may receive both the unicast and multicast (or broadcast) of the same routing information.
• If a specified neighbor is not directly connected, disable source address check on incoming updates.
Configuring TRIP
In a connection oriented network, a router may establish connections to multiple remote routers. In a
WAN, links are created and removed as needed. In such applications, a link created between two
nodes for data transmission is temporary and infrequently.
TRIP should be enabled when it is necessary to exchange routing information through on-demand links
or triggered RIP.
Enabling TRIP
To enable TRIP:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable RIP.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Return to system view. quit N/A
4. Enter interface view.
interface interface-type
interface-number
N/A
5. Enable TRIP. rip triggered Disabled by default
NOTE:
If RIP is disabled, TRIP is also disabled.
Configuring TRIP retransmission parameters
You can specify the interval and count for retransmitting a request or response as needed.
For two routers on an analog dial-up link, the difference between retransmission intervals on the two ends
must be greater than 50 seconds; otherwise, they cannot become TRIP neighbors.
To configure TRIP retransmission parameters:
Step Command Remarks
1. Enter system view. system-view N/A