H3C Technologies H3C SR8800 - Manual (Page 196)

180
System Id: 0000.0000.0001
Interface: GigabitEthernet1/1/1 Circuit Id: 0000.0000.0001.01
State: Up HoldTime: 7s Type: L1 PRI: 100
System Id: 0000.0000.0002
Interface: GigabitEthernet1/1/1 Circuit Id: 0000.0000.0001.01
State: Up HoldTime: 23s Type: L1 PRI: 64
[RouterC] display isis interface
Interface information for ISIS(1)
---------------------------------
Interface: GigabitEthernet1/1/1
Id IPV4.State IPV6.State MTU Type DIS
001 Up Down 1497 L1/L2 No/No
# Display information about IS-IS neighbors and interfaces of Router D.
[RouterD] display isis peer
Peer information for ISIS(1)
----------------------------
System Id: 0000.0000.0001
Interface: GigabitEthernet1/1/1 Circuit Id: 0000.0000.0001.01
State: Up HoldTime: 7s Type: L2 PRI: 100
System Id: 0000.0000.0002
Interface: GigabitEthernet1/1/1 Circuit Id: 0000.0000.0001.01
State: Up HoldTime: 26s Type: L2 PRI: 64
[RouterD] display isis interface
Interface information for ISIS(1)
---------------------------------
Interface: GigabitEthernet1/1/1
Id IPV4.State IPV6.State MTU Type DIS
001 Up Down 1497 L1/L2 No/No
Configuring IS-IS route redistribution
Network requirements
As shown in Figure 66 , Router A, Router B, Router C and Router D reside in the same AS. They use IS-IS
to interconnect. Router A and Router B are Level-1 routers, Router D is a Level-2 router, and Router C is a
Level-1-2 router.
Redistribute RIP routes into IS-IS on Router D.