H3C Technologies H3C SR8800 - Manual (Page 385)

369
system-view
[RouterA] ipv6
[RouterA] bgp 65008
[RouterA-bgp] router-id 1.1.1.1
[RouterA-bgp] ipv6-family
[RouterA-bgp-af-ipv6] peer 10::1 as-number 65009
[RouterA-bgp-af-ipv6] quit
[RouterA-bgp] quit
# Configure Router B.
[RouterB] bgp 65009
[RouterB-bgp] ipv6-family
[RouterB-bgp-af-ipv6] peer 10::2 as-number 65008
[RouterB-bgp-af-ipv6] quit
[RouterB-bgp] quit
# Display IPv6 peer information on Router B.
[RouterB] display bgp ipv6 peer
BGP local router ID : 2.2.2.2
Local AS number : 65009
Total number of peers : 3 Peers in established state : 3
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
10::2 65008 3 3 0 0 00:01:16 Established
9:3::2 65009 2 3 0 0 00:00:40 Established
9:1::2 65009 2 4 0 0 00:00:19 Established
# Display IPv6 peer information on Router C.
[RouterC] display bgp ipv6 peer
BGP local router ID : 3.3.3.3
Local AS number : 65009
Total number of peers : 2 Peers in established state : 2
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
9:3::1 65009 4 4 0 0 00:02:18 Established
9:2::2 65009 4 5 0 0 00:01:52 Established
Router A and B established an EBGP connection; Router B, C and D established IBGP connections
with each other.
IPv6 BGP route reflector configuration
Network requirements
As shown in the following figure, Router B receives an EBGP update and sends it to Router C, which is
configured as a route reflector with two clients: Router B and Router D.
Router B and Router D need not establish an IBGP connection because Router C reflects updates between
them.