H3C Technologies H3C SR8800 - Manual (Page 317)

301
Configuration prerequisites
Before you configure OSPFv3 network types, complete the following tasks:
• Configure IPv6 functions.
• Configure OSPFv3 basic functions.
Configuring the OSPFv3 network type for an interface
To configure the OSPFv3 network type for an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure a network type for
the OSPFv3 interface.
ospfv3 network-type { broadcast |
nbma | p2mp [ non-broadcast ] |
p2p } [ instance instance-id ]
Optional.
The network type of an interface
depends on the media type of the
interface.
Configuring an NBMA or P2MP neighbor
For NBMA and P2MP interfaces (only when in unicast mode), you must specify the link-local IP addresses
of their neighbors because such interfaces cannot find neighbors via broadcasting Hello packets. You
can also specify DR priorities for neighbors.
To configure an NBMA or P2MP (unicast) neighbor and its DR priority:
Step Command
1. Enter system view. system-view
2. Enter interface view. interface interface-type interface-number
3. Specify an NBMA or P2MP
(unicast) neighbor and its DR
priority.
ospfv3 peer ipv6-address [ dr-priority dr-priority ] [ instance
instance-id ]
Configuring OSPFv3 routing information control
This section describes how to configure the control of OSPF routing information advertisement and
reception, and redistribution from other protocols.
Configuration prerequisites
Before you configure OSPFv3 routing information control, complete the following tasks:
• Enable IPv6.
• Configure OSPFv3 basic functions.